SOP for Cleaning of Multi Mill

1.0 OBJECTIVE:

To lay down the cleaning procedure for multi mill.

2.0 SCOPE:

This SCP shall be applicable for multi mill used in Manufacturing area in Production department.

3.0 RESPONSIBILITY:

3.1 Execution :Operator
3.2 Checking :Pharmacist and Above

4.0 ACCOUNTABILITY:

HOD-Production

5.0 PROCEDURE:

5.1 Put “OFF” the electrical supply and cover motor, starter with polythene bag.
5.2 Remove hopper, cover (chamber), screen guard, and blades by opening of wing nut then clean with 50 liter Potable water.
5.3 Further clean with 2.5 % “Teepol” solution using scrubber. Rinse with 25 liter Potable water thoroughly.
5.4 Apply 25 liter hot water to all the cleaned items and allow the water to drain. Finally rinse with about 50 liter purified water.
5.5 Clean the stand, top plate and shaft using 10 liter of potable water with 2.5% Teepol solution and rinse with 15 liter potable water thoroughly. Finally rinse with about 25 liter purified water.
5.6 Wipe out with dry clean lint free cloth and with 70% IPA.
5.7 Affix "Cleaned" Label and fill the “Equipment Log Book”.
5.8 Re-clean if not used within 72 hours.

6.0 ABBREVIATION:

SCP :Standard Cleaning Procedure
IPA :Isopropyl Alcohol

Get ready to use editable SOPs in MS-Word FormatView List

Share

Tweet

Share

Share